Widget Image
About Us

Arandas born on April 13, 2005 as a full-service auto repair, since we made a serious, honest, and guaranteed promise in which our primary concern is the satisfaction of our customers.

Arandas Auto Services has a team of professional diagnosis, a staff with the capacity and expertise to meet the needs of your car, visit us we would be happy to assist you.

 

Production Circuit

This circuit is composed of a generator can be a DYNAMO in the oldest cars that would responsible for producing DC or an alternator that produces alternating current and becomes continuous.

The electricity is produced when the engine by V-belt drives the generator. Limit the voltage regulator and the current intensity in general. The current produced reaches the vehicle battery.

This is generally composed of six vessels in which we find: A beam of positive plates interleaved with other negative plates. Separators that isolate the two types of electrolyte (liquid) plates covering plates.

Each glass generates around 2 volts tension. Connected as a total voltage of 12 volts which is operating the vehicle are in series generally. Of the positive plates, or get a positive terminal to the external circuit and the negative plates of a connector or negative.

The battery should have enough stored electricity to start the engine and power the circuitry necessary if engine stop or meet this turning at low speeds.

IGNITION CIRCUIT

  • Battery: It supplies current low voltage (typically 12 V)
  • Coil: It transforms the current low voltage (12 volts)
  • Distributor: carrying high voltage current to the spark plugs.

The Battery

The Battery should have enough stored electricity to start the engine and power the circuits needed in case of engine shutdown or meet is spinning at low revs.

Keep your battery holds good without rust on the terminals (with petroleum jelly or grease to prevent sulfation) dry vehicle. With the level ectrolito (liquid mixture of sulfuric acid and distilled water) at least an inch above the plates by adding distilled water only.

The low maintenance batteries require a relaxed alertness (every 6months) of electrolyte level. The maintenance free batteries must not lose fluid, so this monitoring is not necessary. When replacing or disconnecting a battery, first remove the negative and then the positive cable. When connecting do the opposite, first connect the positive and then the negative.